There’s not much in the way of trying out your plumbing configuration in new home construction till you move into the house and begin to use the water system regularly. When the plumbing is first installed into a new home, it goes through a pressure test to guarantee there aren’t any leaks in the system. This is the sole test that may be done till the house owner moves in and contacts the power corporation to have the water turned on.
Many times, although the water lines are pressurized with air, it isn’t feasible to find all of the leaks – if they exist. When the water is at first turned on, it can wash any loosely sealed areas of the piping away.Due to this, it’s not rare for little leaks to be noted in the plumbing after new home construction.
In most cases, leaks can happen around threaded joints, but can also happen in fixed joints. After the water is turned on for the 1st time, a plumber can tighten the joints with the standard plumbing wrench to guarantee they’re tight and not dribbling. They could have to use new plumbing sealer to be sure that no further leaks are achievable.
In a joint that has already been glued, however, the pipe will have to be cut out and replaced with a new one because there is no way to seal a glued joint without breaking it open. This type of leak is most common in the basement or foundation of the house near the water heater and hot water lines. The water pressure coupled with the heat of the water can lead to this type of leak.
Another common issue with plumbing in the new home is with the fixtures. It is important to check over all the water fixtures in new construction when the homeowner moves in to ensure that plumbers and installers correctly tightened them. It is possible that a faucet or a knob wasn’t tightened properly during installation.
It is also possible that the plumber may have tightened a fixture too much, causing damage. For this reason, it is important that homeowners properly look over any and all faucet, toilet, and tub fixtures before they begin regular use.
After your initial inspection of your new home’s plumbing system when the water is first hooked up, you should perform another inspection after 30 days. Leaks can sometimes show themselves after a month of regular use. If your plumbing is showing no signs of leaks or problems after 30 days, you can rest assured that your plumbing is in good condition and will last for many years to come. It is mainly a good idea to perform annual inspections of your pipes to repair any potential problems before they become a larger, more expensive issue.
To sum up, its advisable to contact a professional plumbing service provider who has been trained and certified with licensing, for an effective and perfect work to be done to avoid regrets in the future.